portheavy.blogg.se - I pilot remote battery indicator

I PILOT REMOTE BATTERY INDICATOR BLUETOOTH

Verify the battery is installed correctly with the positive side of the battery facing out.To turn on the remote, press any button.

Legacy i-Pilot Remote i-Pilot Remote will not turn on.After cleaning the terminals, clean any residue from the battery area and replace the batteries with new batteries.If you need to scrub the terminals, you can gently scrub them with a cotton swab or a toothbrush. Once the fizzing stops, you can clean the terminals and wipe away any residue.You can spread the vinegar or lemon juice around with a cotton swab. Put a drop or two on the corrosion and wait for it to stop fizzing. Use vinegar or lemon juice to neutralize the acid.You should always wear protection when cleaning the battery terminals for safety. The leakage is battery acid and very corrosive. Corrosion on Battery Terminals Corrosion on the battery terminals can be caused by batteries leaking.Turn the system OFF and then back ON (for PowerDrive models, disconnect then reconnect power).Re-pair/re-learn the remote to the Controller.For all other motors verify the motor is turned on, a system ready or power light will be illuminated (on the base of the motor on all Terrova/Ulterra Models, on the foot pedal on Ultrex).For PowerDrive Motors press the “Push-to-Test” battery meter to verify voltage to the motor and check the connection to the foot pedal plug is secure.Verify the i-Pilot Controller has power.

I PILOT REMOTE BATTERY INDICATOR BLUETOOTH

"Motor Not Found" Error for Bluetooth i-Pilot If your Bluetooth i-Pilot Remote shows "Motor Not Found" the i-Pilot remote is not able to communicate with the i-Pilot Controller built into the trolling motor.

RF Error on Bluetooth i-Pilot Remote If your Bluetooth i-Pilot remote is displaying "RF" on the screen, this is a fatal error for the remote.

If the remote will not turn on and has 3 brand new batteries and they are inserted correctly, the remote will need to be replaced.

Verify the batteries are inserted correctly.

If the remote does not turn on, replace the batteries.

To turn on the remote, press and hold the OK button for 3 seconds.

Bluetooth i-Pilot Remote will not turn on.

Legacy i-Pilot and i-Pilot Link Systems Troubleshooting Guide If you would like additional assistance with troubleshooting your i-Pilot, click on the button below to access the Bluetooth i-Pilot® and i-Pilot Link Systems Troubleshooting Guide or the Legacy i-Pilot® and i-Pilot Link Systems Troubleshooting Guideīluetooth i-Pilot and i-Pilot Link Systems Troubleshooting Guide

The most common issues for Bluetooth i-Pilot Remotes and Legacy i-Pilot Remotes are listed below.